Written by
Elena Navarro Appliance Repair Content SpecialistPublished September 11, 2026Updated October 20, 2026
Error codeF2
ApplianceRange
Quick answer
F2 is a general fault location on legacy Dacor ER ranges and is usually followed by a more specific code.
Model compatibility: Dacor reuses codes across series and model years, so F2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
General fault location: communication between control panel and relay board; usually followed by a specific code.
F2 is a starting point rather than a final answer on a Dacor range. The Technical Manual describes it as a general fault location: communication between the control panel and the relay board. It is usually followed by a specific code, so watch the display for the one that comes next. The entry covers the legacy ER30D, ER36D and ER48D ranges.
What to do with F2
Note which code follows F2 and pass both along when you call. The manual says to look for obvious problems first, for example a main power switch that is off or a locked control panel.
Specific codes to compare
F20: loose or defective data cable between the relay board and control panel, or a defective control panel circuit board.
F32: the same kind of cable fault, or a defective membrane.
If F2 stays on a Dacor range in Los Angeles, call (310) 742-1907 for Dacor range repair. Tell the technician both codes you saw, the model number and what you have tried so far.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Dacor appliance?
Book a specialist visit for a clear estimate and approval before any repair.
