Written by
Elena Navarro Appliance Repair Content SpecialistPublished September 11, 2026Updated October 20, 2026
Error codeF1
ApplianceRange
Quick answer
F1 on Dacor ER30D/ER36D/ER48D ranges points to the control panel controller board and is usually followed by a specific code.
Model compatibility: Dacor reuses codes across series and model years, so F1 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
General fault location: internal (control panel controller board); usually followed by a specific code.
F1 on a Dacor ER30D, ER36D or ER48D range is a general code. It marks the problem as internal, meaning it was found by the controller board in the control panel. This is an older series.
Watch for the second code
F1 is normally followed by a more specific code, and that second code is the one that tells you what failed. Write both down. The general codes are F1 internal, F2 communication between control panel and relay board, F3 external and F9 door lock.
What an owner can check
The manual begins with the obvious: whether the main power switch has been turned off, and whether the control panel is locked. Anything beyond that is for a technician.
Specific codes to compare
F10 is a shorted element relay or sensor wiring issue, F13 is a control panel failure, and F14 is a defective power board.
Dacor range repair in Los Angeles
Call (310) 742-1907 about a Dacor range in Los Angeles. Report F1 along with the code that follows it, plus your model number. See range repair for what we cover.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Dacor appliance?
Book a specialist visit for a clear estimate and approval before any repair.
